Tag Archives: airtight membrane
One of the most commonly used, and widely recognised, acronyms in construction is VCL, which stands for vapour control layer. A VCL is a critical building component designed to protect the building from potential degradation (or poor performance) by managing the passage of water vapour within a building structure. In other words, it is used to manage condensation risk. Condensation is formed when warm moist air condenses into a liquid on contact with a colder surface. A vapour control layer is typically installed on the internal side of the insulation to control the passage of warm moist air (water vapour) entering the structure. However, as a simple acronym, there is a problem because in most applications a specific level or type of performance is required, as a ‘catch all’ acronym VCL is wide open to error.
Based on the envelope area of a 1,900 square foot certified Passive House If built just to building regulations (a leakage rate 10m3/hr/m2) the equivalent size hole in the building once everything has been sealed up would be approximately 440 x 440mm. Whereas what was achieved on this Passivhaus was a leakage area that is 10 times smaller at just 44 x 44mm To put this leakage area into perspective, if a building was built to the backstop allowable leakage rate for building regulations, you could leave a hole in the wall the size of a typical ATM